Secure Mobile Solutions - Security
SLE 66CL80P
16-Bit High Security Dual Interface Controller
ISO/IEC 7816 and 14443 Type A & B Compliant Interfaces
For Contact and Contactless Operation
with Memory Management and Protection Unit
in 0.22 m CMOS Technology
72-Kbyte ROM, 2-Kbyte RAM, 8-Kbyte EEPROM
112-Bit / 192-Bit DDES-EC2 Accelerator
supporting DES, 3DES and Elliptic Curve GF(2
n
)
Short Product Information
April 2004
SLE 66CL80P Short Product Information
Ref.: SPI_SLE66CL80P_0404.doc
This document contains preliminary information on a new product under development.
Details are subject to change without notice.
Revision History:
Current Version 2004-04-01
Previous Releases: 2004-02-12
Page
3
Type A baud rate support of 106 kbit/s
Important: Further information is confidential and on request. Please contact:
Infineon Technologies AG in Munich, Germany,
Secure Mobile Solutions - Security
Tel +49 - (0)89 234-80000
Fax +49 - (0)89 234-81000
E-Mail: security.chipcard.ics@infineon.com
Published by Infineon Technologies AG, SMS Security Applications Group
St.-Martin-Strasse 53, D-81541 Mnchen
Infineon Technologies AG 2004
All Rights Reserved.
To our valued customers
We constantly strive to improve the quality of all our products and documentation. We have spent an exceptional
amount of time to ensure that this document is correct. However, we realise that we may have missed a few things. If
you find any information that is missing or appears in error, please use the contact section above to inform us. We
appreciate your assistance in making this a better document.
Attention please!
The information herein is given to describe certain components and shall not be considered as warranted
characteristics.
Terms of delivery and rights to technical change reserved.
We hereby disclaim any and all warranties, including but not limited to warranties of non-infringement, regarding
circuits, descriptions and charts stated herein.
Infineon Technologies is an approved CECC manufacturer.
Information
For further information on technology, delivery terms and conditions and prices please contact your nearest Infineon
Technologies Office in Germany or our Infineon Technologies Representatives world-wide (see address list).
Warnings
Due to technical requirements components may contain dangerous substances. For information on the types in
question please contact your nearest Infineon Technologies Office.
Infineon Technologies Components may only be used in life-support devices or systems with the express written
approval of Infineon Technologies, if a failure of such components can reasonably be expected to cause the failure of
that life-support device or system, or to affect the safety or effectiveness of that device or system. Life support devices
or systems are intended to be implanted in the human body, or to support and/or maintain and sustain and/or protect
human life. If they fail, it is reasonable to assume that the health of the user or other persons may be endangered.
SLE 66CL80P
Short Product Information
3 / 10
2004-04-01
16-Bit High Security Dual Interface Controller
ISO/IEC 7816 and 14443 Type A &B Compliant Interfaces
For Contact and Contactless Operation with MMU in 0.22 m CMOS Technology
72-Kbyte ROM, 2304-byte RAM, 8-Kbyte EEPROM
112-Bit / 192-Bit DDES-EC2 Accelerator
supporting DES, 3DES and Elliptic Curve GF(2n)
Features
Enhanced low power 8051 CPU with
extended addressing modes for contact
and contactless smart card applications
Instruction set opcode compatible with
standard 8051 processor with additional
powerful instructions optimized for smart
card application
Dedicated, non-standard architecture with
execution time 6 times faster (18 times
using PLLmax) than standard 8051
processor at same external clock
70 Kbytes User ROM for operating system
and application (programs & data)
2 Kbytes reserved ROM for Resource
Management System (RMS_E) with
Contactless Optimized EEPROM
write/erase routines
8 Kbytes Secure EEPROM in SuperSlim
technology for application program and
data
2048 bytes XRAM and 256 bytes internal
RAM for fast data processing
Memory Management Unit
Certified True Random Number
Generator
Dual Key Triple DES (DDES) &
GF
(2
n
) Elliptic Curve (EC2) Accelerator
CRC Module according to ISO/IEC 3309
supporting CCIT v.41 & HDLC X25
8 Interrupt Vectors Module with 3 priority
levels to ensure real time operation
PLL: to speed up the internal CPU clock
frequency up to 15MHz (optional use)
Two 16-bit Timer with interrupt capability
for protocols, security checks & watch dog
implementations
Power saving sleep and clock stop modes
Temperature range:
contact-based: -25C to +85C
contact-less: -25C to +70C
Full operation either via Contact-based
and/or Contactless interfaces
controlled by Operating System
enhances Security Level
Contact-based Interface
Contact configuration and serial
interface according to ISO/IEC 7816
UART handling serial interface compliant
with ISO/IEC 7816 supporting
transmission protocols T=0 and T=1
Supply voltage range:
5V 10% (Class A)
3V 10% (Class B)
Current consumption < 10 mA @ 5.5 V
External CPU clock frequency:
1 to 7.5 MHz
Internal CPU clock frequency:
up to 15 MHz
ESD protection larger than 6 kV
Contactless Interface
Interface compliant to ISO/IEC 14443 for
both Type A and Type B
Carrier frequency 13.56 MHz
Data rate
106 Kbit/s in type A operation
up to 848 Kbit/s in type B operation
Anticollision & Transmission Protocol
supported by open source application
notes for both Type A & B
Flexible Internal CPU clock frequency:
from 1.7MHz up to 15 MHz
256 bytes buffer for contactless data
exchange (FiFo circular architecture)
Parallel operation of CPU, Peripherals
like DES, CRC and Contactless Interface
possible
SLE 66CL80P
Short Product Information
4 / 10
2004-04-01
EEPROM (SuperSlim Technology)
Byte wise EEPROM programming and read
accesses
Versatile & Flexible page mode for 1 to 256
bytes write/erase operation
32 bytes security area including:
- 16 bytes chip unique identification number
- 16 bytes PROM area (OTP like)
Fast personalisation mode 1.5 ms
Typical Page Erase time < 2.5ms
Typical Page Writing time < 1.8 ms
Minimum of 100.000 Write/erase cycles
1)
Data retention for a minimum of 10 years
1)
EEPROM programming voltage generated
on chip
Memory Management and Protection
Unit
Addressable memory up to 1 Mbytes
Separates OS (system mode) and
Application (application mode)
System routines called by traps
Access Restrictions to peripherals in
application mode controlled by OS
Code execution from XRAM possible
Security Features
Operation state monitoring mechanism
The chip goes in a secure reset state on any
following sensors alarm:
Low and high voltage sensors
Internal voltage sensor
Frequency sensors and filters
Light sensor
Glitch sensor
Temperature sensor
Life Test Sensor
Internal power-on reset sensor
Active Shield with automatic and user
controlled attack detection
1)
Values are temperature dependant
Secure chip and firmware design
Security scrambled & optimized chip
layout against physical chip manipulation
Memory encryption/decryption module
(MED) for XRAM, ROM and EEPROM
against reverse engineering and power
attacks
ROM code not visible due to implantation
Mask dependant ROM code encrypted
during production
Chip Unique encryption of the XRAM and
EEPROM
Flexible encryption of part or whole
EEPROM by additional user-defined key
16 byte Unique chip identification number
for anti-clone countermeasure & tracking
16 bytes security PROM hardware
protected (OTP like)
Secure start of the operating system
ensured by certified Self Test Software
(STS)
Certified EEPROM programming routines
(RMS_E)
True Random Number Generator with
Firmware test function
High Speed SPA/DPA resistant Triple
DES (DDES) Accelerator
Anti Snooping
HW-countermeasures against SPA/DPA-,
Timing- and DFA-attacks (differential fault
analysis)
Supported Standards
ISO/IEC 7816
EMV 2000
GSM 11.1x
ETSI TS 102 221
ISO/IEC 14443
ISO/IEC 3309
CCIT v.41
HDLC X25
SLE 66CL80P
Short Product Information
5 / 10
2004-04-01
Application Support
HW-& SW-Tools (Emulator, ROM Monitor,
Card Emulator, Simulator,
Evaluation Kit
Proximity (
Contactless Reader package),
SmartMaskTM package, Simulated Reader
Software, etc.)
Open Source Application Notes Tutorial
(e.g.: T=0, T=1, DES and 3DES, Crypto
Library, Anticollision and Contactless
Transmission Protocols for both Type A
and B, Card Coil Design Guide, Card Coil
Antenna Reference Design List, etc.)
Certified CC EAL5+ Crypto Library
Worldwide Application Engineer Team and
customer dedicated Field Application
Engineers
Regular Customer trainings on
Cryptography, Contactless and Dual
interface controllers including ISO/IEC
14443 related topics
On-site trainings available on request
Document References
Confidential Data Book SLE 66CxxP
Confidential Instruction SLE 66CxxP
Confidential Quick Reference SLE 66CxxP
Chip Qualification report
Chip delivery specification for wafer with
chip-layout (die size, orientation, ...)
Module specification containing description
of package, etc.
Module Qualification report
Development Tools Overview
Software Development Kit SDK CC
Card Emulator CE66P Dual Interface
ROM Monitor RM66P-II with stand alone
functionality for ROM mask qualification in
the end user system
Emulator ET66P Hitex or ET66P KSC
Smart MaskTM Package for chip evaluation
Smart MaskTM Dual Interface modules
M8.4 supporting both ISO/IEC 14443 Type
A & B and ISO/IEC 7816 for implantation
process testing and production setup
Evaluation Kit Proximity (Contactless
reader package)
PDF 
ZIP