MSC1377.PDF
ISO 9001 CERTIFIED
REV C 1/27/2000
8700 E. Thomas Road
Scottsdale, AZ 85251
Tel: (480) 941-6300
Fax: (480) 947-1503
DESCRIPTION (300 watt)
This 3 pin
ULTRA LOW CAPACITANCE TRANSIENT VOLTAGE
SUPPRESSOR is designed for use in applications where protection is
required at the board level from voltage transients caused by
electrostatic discharge (ESD) as defined by IEC 1000-4-2, electrical
fast transients (EFT) per IEC 1000-4-4.
This product provides
unidirectional protection for 1 line by connecting
the Input/Output line to pin 1, pin 2 to common or ground and pin 3 (is
not connected). The SL03 thru SL24 product provides board level
protection from static electricity and other induced-voltage surges that
can damage sensitive circuitry.
These TRANSIENT VOLTAGE SUPPRESSOR (TVS) Diode Arrays protect 3.0/3.3 Volt components such
as DRAM's, SRAM's, CMOS, HCMOS, HSIC, and low voltage interfaces up to 24 Volts. Because of the
physical size, weight and protection capabilities, this product is ideal for use in but not limited to
miniaturized electronic equipment such as hand held instruments, computers, computer peripherals and
cell phones.
FEATURES
Protects 3.0/3.3 up through 24V Components
Protects 1 Unidirectional line
Provides electrically isolated protection
SOT-23 Packaging
MAXIMUM RATINGS
Operating Temperatures: -55
C to +150
C
Storage Temperature: -55
C to +150
C
SL03 thru SL24 have a Peak Pulse Power: 300 Watts
(8/20
sec, Figure 1)
Pulse Repetition Rate: <.01%
ELECTRICAL CHARACTERISTICS @ 25
C Unless otherwise specified
STAND
OFF
VOLTAGE
V
WM
VOLTS
BREAKDOWN
VOLTAGE
V
BR
@1 mA
VOLTS
CLAMPING
VOLTAGE
V
C
@ 1 Amp
(FIGURE 2)
VOLTS
CLAMPING
VOLTAGE
V
C
@ 5 Amp
(FIGURE 2)
VOLTS
LEAKAGE
CURRENT
I
D
@ V
WM
A
CAPACITANCE
@0V, 1 MHz
C
pF
TEMPERATURE
COEFFICIENT
OF V
BR
VBR
mV/C
PART
NUMBER
DEVICE
MARKING
MAX MIN MAX MAX MAX MAX MAX
SL03 L03 3.3 4 8 11 200 3 -5
SL05 L05 5.0 6.0 10.8 13 100 3 3
SL12 L12 12.0 13.3 19 26 1 3 10
SL15 L15 15.0 16.7 25 32 1 3 13
SL24 L24 24.0 26.7 44 57 1 3 30
NOTE: Transient Voltage Suppression (TVS) product is normally selected based on its stand off Voltage V
WM
. Product
selected voltage should be equal to or greater than the continuous peak operating voltage of the circuit to be protected.
SL03
thru
SL24
TVSarray
TM
TM
Series
PACKAGING
Tape & Reel EIA Standard 481
7 inch reel 5,000 pieces
13 inch reel 10,000 pieces
MECHANICAL
Molded SOT-23 Surface Mount
Weight: .014 grams (approximate)
Body Marked with device number
PDF 
ZIP