PTI 6037
NATIONAL HYBRID INC.
RONKONKOMA, N.Y. 11779
Miniature, Hermetically Sealed
Optocoupler NHI 6037
Features;
-55c to +125c Operation
Output Voltage to 30V
Input Current from < 2mA
Low Output Saturation Typ < 0.3V
Withstanding Voltage > 1500Vdc
High Radiation Tolerance
Functionally Compatible with 4N37
Absolute Maximum Ratings;
Supply Voltage (Vcc) ......................................... -0.5 to 30Vdc
Continuous Input Current .................................... 60mA
Peak Input Current If (10uS,300Hz) ....................... 3A
Reverse Input Voltage Vr .................................... 5 Vdc
Led Power Dissipation (At Tc=25c)....................... 100mW
Output Current .................................................. 100mA
Output Voltage ..................................................-0.5 to 30Vdc
Output Power Dissipation .................................... 300mW
Storage Temperature ......................................... -65C to 150C
Lead Solder Temperature ................................... 260C for 10 sec.
Junction Temperature .........................................175C
Recommended Operating Conditions;
Output Voltage Range .................................................... to 30Vdc
Input Current ................................................................... 0.5 mA to 15mA
Ambient Operating Temperature Range ........................ -55C to 125C
Electrical Performance Characteristics;
(At Ta = 25c
unless otherwise specified)
Terminal
Number
Terminal
Function
1
ANODE
2
CATHODE
3
EMITTER
4
COLLECTOR
Page1
1
2
4
3
COLLECTOR
EMITTER
ANODE
CATHODE
PTI-6037
PTI 6037
Switching Characteristics:
(at Ta = 25C) unless otherwise specified)
Page2
Non-saturated
Turn on time
Ton
Ic = 2mA, Rl = 100ohm, Vcc = 5V
7.0
uS
Non-saturated
Turn off time
Toff
Ic = 2mA, Rl = 100ohm, Vcc = 5V
7.0
uS
Saturated
Turn-on time
Ton
If = 16mA, Rl = 2.0K, Vcc = 5V
5.0
uS
Saturated
Turn-off time
Toff
If = 16mA, Rl = 2.0K, Vcc = 5V
40.0
uS
TEST
SYM-
BOL
CONDITIONS
LIMITS
MIN MAX
UNITS
Current Transfer
Ratio
Ctr
Vce = 10V, If =10mA (at Ta = 25C) _1
Vce = 10V, If =10mA (at Ta = -55C) _1
Vce = 10V, If =10mA (at Ta = 125C) _1
100
50
50
%
Collector - Emitter
breakdown Voltage
Vceo Ic = 100uA
30 60
Vdc
Emitter - Collector
Breakdown Voltage
Veco Ie = 10Ua
5.0 7.5
Vdc
Output Saturation Voltage
Vce
(sat)
If=10mA , Ic=1.0mA
0.3
Vdc
High Level Output
Current (dark current)
Iceo Vcc = 30V, If = 0A (at Ta = 125C)
500
Adc
Input Forward Voltage
Vf
If = 10mA
1.7
Vdc
Input Reverse Breakdown
Voltage
Vbr
Ir = 10A
5.0 30
Vdc
PTI 6037
PTI 6037
_1 Ctr is defined as the ratio of the Output Collector current (Io) to the LED Forward Current ( If ), times 100%.
_2 Device is considered a two terminal device. Pins 1 and 2 are shorted together and pins 4,and 5 are shorted
together.
_3 Measured between the LED cathode and pins 4 and 5 (shorted together).
_4 Parameters shall be tested as part of the device's initial characterization . Parameters are guaranteed to the limits
specified for all lots not specifically tested.
_5 Cmh is the maximum common mode transient to assure that the output will remain in a high logic state (Vo > 2.0V).
_6 In applications where dV/dt may exceed 50,000 Vs a series resistor must be included in the Vcc line to limit
destructively high surge currents. The recomended value, at If = 0.5mA, is 3.3K
_7 Cml is the maximum common mode transient to assure that the output will remain in a low logic state (Vo < 0.8V).
Notes;
TEST
SYM-
BOL
CONDITIONS
LIMITS
MIN MAX
UNITS
Capacitance, input to output
Cio
f = 1Mhz, Ta = 25C _ 3_4
4
pF
Common Mode Transient
Immunity, high output
Cmh
Vcm = 25v (peak)
Vcc = 5.0v, Rl = 2.0K _4_5_6
If = 0mA,
500
V/s
Common Mode Transient
Immunity, lo output
Cml
Vcm = 25v (peak)
Vcc = 5.0v, Rl = 2.0K _4_5_6
If = 0mA,
500
V/s
Input to Output Insulation
Leakage Current
Iio
Vio = 1500Vdc,
Relative Humidity = 5%,
1.0
Adc
Page3
Isolation Characteristics:
(at Ta = 25C unless otherwise specified)
PTI 6037
Vcc2
1 Mhz
TTL
Test
Waveform
1 uf
+
1
2
4
3
PTI-6037
200
2K
Page4
Vcc2
Test
Waveform
1 uf
1 uf
+
+
82
H/L
L/H
+3v
Vcm 25 Vpp
1
2
4
3
PTI-6037
2K
Ton
Toff
Input
Waveform
Output
Waveform
0V
25Vpp
Vo = 0.8Vmax
Vo = 2.0 min
Fig 1 Switching Time Test Circuit
Fig 2 Common Mode Test circuit
Fig 3 Switching Time Test Waveform
Fig 4 Common Mode Test Waveform
PTI 6037
Page5
TYPICAL P.C. PATTERN
0.160
0.075 MAX
0.110 MAX
0.032
PIN 1
0.050
0.035
PIN 1
PIN 1
0.120
0.120
LEADLESS
OPTION (-Z)
GULLWING
OPTION (-X)
0.035
0.04
0.16
2.2984
0.025
PDF 
ZIP