LCY-03115C-1
NOTICE
This publication is the proprietary of SHARP and is copyrighted, with all rights reserved.
Under the copyright laws, no part of this publication may be reproduced or transmitted in any
form or by any means, electronic or mechanical for any purpose, in whole or in part, without
the express written permission of SHARP. Express written permission is also required before
any use of this publication may be made by a third party.
The application circuit examples in this publication are provided to explain the representative
applications of SHARP's devices and are not intended to guarantee any circuit design or permit
any industrial property right or other rights to be executed. SHARP takes no responsibility
for any problems related to any industrial property right or a third party resulting from the
use of SHARP's devices, except for those resulting directly from device manufacturing processes.
In the absence of confirmation by device specification sheets, SHARP takes no responsibility
for any defects that occur in equipment using any of SHARP's devices, shown in catalogs, data
books, etc. Contact SHARP in order to obtain the latest device specification sheets before
using any SHARP's device.
SHARP reserves the right to make changes in the specifications, characteristics, data,
materials, structures and other contents described herein at any time without notice in order
to improve design or reliability. Contact SHARP in order to obtain the latest specification
sheets before using any SHARP's device. Manufacturing locations are also subject to change
without notice.
Observe the following points when using any device in this publication. SHARP takes no
responsibility for damage caused by improper use of the devices.
The devices in this publication are designed for
general electronic
equipment use.
The appropriate design measures should be taken to ensure reliability and safety when SHARP's
devices are used for equipment such as:
Transportation control and safety equipment(i.e.,aircraft, trains, automobiles, etc.)
Traffic signalsGas leakage sensor breakers Alarm equipmentVarious safety devices etc.
SHARP's devices shall not be used for equipment that requires extremely high level of
reliability, such as:
Military and space applications Nuclear power control equipment
Medical equipment for life support
Contact a SHARP representative, in advance, when intending to use SHARP
's devices for any
"specific" applications other than those recommended by SHARP.
Contact and consult with a SHARP representative if there are any questions about the contents
of this publication.
LCY-03115C-2
1. Application
This specification applies to color TFT-LCD module, LQ8S3G.
2. Overview
This module is a color active matrix LCD module incorporating amorphous silicon TFT (Thin Film
Transistor).
It is composed of a color TFT-LCD panel, driver ICs, control circuit and powersupply circuit and a
backlight unit. Graphics and texts can be displayed on a 8003600 dots panel with 262,144 colors by
supplying 18 bit data signal (6bit/color), two timing signals, +3.3V DC supply voltage for TFT-LCD
panel driving and supply voltage for backlight.
The TFT-LCD panel used for this module is a low-reflection and higher-color-saturation type.
Therefore, this module is also suitable for the multimedia use.
Viewing angle is 6 o
'clock direction.
This module is the type of wide viewing angle and high brightness(30cd/m
2
).
Backlight-driving DC/AC inverter is not built in this module.
This module is adapted to RoHS compliance.
3. Mechanical Specifications
Parameter
Specifications
Unit
Display size Diagonal
21.3 (8.4"type)
cm
Active Display area
170.4(H)127.8(V)
mm
Pixel format
800(H)600(V)
pixel
(1 pixelRGB dots)
-
Pixel pitch
0.213(H)0.213(V)
mm
Pixel configuration
R,G,B vertical stripe
-
Display mode
Normally white
-
Dimension *1
199.5(W) 149.5(H)11.6 (D)
mm
Mass
(MAX.)
g
*1. Protrusions not included. Refer to Fig.1 TFT-LCD Module Structure Diagram for details.
PDF 
ZIP
