RECORDS OF REVISION
LQ150X1LW71N
SPEC No.
DATE
REVISED
SUMMARY
NOTE
No.
PAGE
LD-15218
FEB. 24. 2003
1st Issue
LD-15218A
SEP. 2. 2005
1
COVER Add the document about the ROHS directive
Post name change
Development Engineering Department 2
AVC Liquid Crystal Display Division
AVC Liquid Crystal Display Group
SHARP Corporation
Engineering Department 7
MOBILE LCD DESIGN CENTER 1
MOBILE LIQUID CRYSTAL DISPLAY GROUP
SHARP Corporation
18
Add
R.C.mark (for RoHS)at packing form
LD-15218A-1
1. Application
This specification applies to the color 15.0 XGA TFT-LCD module LQ150X1LW71N.
These specification sheets are the proprietary product of SHARP CORPORATION("SHARP) and include
materials protected under copyright of SHARP. Do not reproduce or cause any third party to reproduce them in
any form or by any means, electronic or mechanical, for any purpose, in whole or in part, without the express
written permission of SHARP.
The device listed in this technical literature was designed and manufactured for use in OA equipment.
In case of using the device for applications such as control and safety equipment for transportation(aircraft,
trains, automobiles, etc. ), rescue and security equipment and various safety related equipment which require
higher reliability and safety, take into consideration that appropriate measures such as fail-safe functions and
redundant system design should be taken.
Do not use the device for equipment that requires an extreme level of reliability, such as aerospace applications,
telecommunication equipment(trunk lines), nuclear power control equipment and medical or other equipment
for life support.
SHARP assumes no responsibility for any damage resulting from the use of the device which does not comply
with the instructions and the precautions specified in these specification sheets.
Contact and consult with a SHARP sales representative for any questions about this device.
LD-15218A-2
2. Overview
This module is a color active matrix LCD module incorporating amorphous silicon TFT (Thin Film Transistor).
It is composed of a color TFT-LCD panel, driver ICs, control circuit, power supply circuit and a back light unit.
Graphics and texts can be displayed on a 1024RGB768 dots panel with about 16 million colors by using
LVDS (Low Voltage Differential Signaling) and supplying +3.3V DC supply voltages for TFT-LCD panel
driving and supply voltage for backlight.
It is a wide viewing-angle-module
(Vertical viewing angle:170Horizontal viewing angle:170,CR10).
3. Mechanical Specifications
Parameter Specifications
Unit
Display size
38 (Diagonal)
cm
15.0 (Diagonal)
Inch
Active area
304.1 (H)228.1
(V) mm
Pixel format
1024 (H)768 (V)
Pixel
(1 pixelR+G+B dots)
Pixel pitch
0.297 (H)0.297 (V)
mm
Pixel configuration
R, G, B vertical stripe
Display mode
Normally black
Unit outline dimensions *1
331.6(W)254.76(H)12.5(D)
mm
Mass
1300(MAX)
g
Surface treatment
Anti-glare and hard-coating 3H
(Haze value = 25)
*1.Note: excluding back light cables.
The thickness of module (D) doesn't contain the projection.
Outline dimensions are shown in Fig.1.
PDF 
ZIP
