S-AU27AL,S-AU27AM,S-AU27AH
2001-02-02 1/3
TOSHIBA RF POWER AMPLIFIER MODULE
S-AU27AL,S-AU27AM,S-AU27AH
25W FM RF POWER AMPLIFIER MODULE
l S-AU27AL
: f = 400~430MHz
l S-AU27AM
: f = 450~490MHz
l S-AU27AH
: f = 490~512MHz
MAXIMUM RATINGS
(Tc = 25C)
CHARACTERISTIC SYMBOL
RATING
UNIT
DC Supply Voltage
V
CC1
16 V
DC Supply Voltage
V
CC2
17 V
DC Supply Voltage
V
CC3
17 V
Total current
I
T
10 A
Input Power
P
i
600
mW
Output Power
P
o
40
W
Operating Case Temperature Range
T
c (opr)
-30~100 C
Storage Temperature Range
T
stg
-40~110 C
ELECTRICAL CHARACTERISTICS
(Tc = 25C)
CHARACTERISTIC SYMBOL
TEST
CONDITION
MIN.
TYP.
MAX.
UNIT
Frequency Range
f
range
400 -- 512
MHz
Output
Power
Po
32 -- -- W
Power Gain
G
p
22.0
--
--
dB
Total Efficiency
T
35
--
--
%
Input VSWR
VSWRin
--
1.5 2.5 --
Harmonics HRM
V
CC1
= V
CC2
= V
CC3
= 12.5V
Pi = 200mW
Z
G
= Z
L
= 50
--
-30
-25
dB
Load Mismatch
--
Po = 35W (V
CC1
= adjust)
V
CC2
= V
CC3
= 15V
Pi = 200mW
VSWR load 20: 1 all phase
No Degradation
Stability --
V
CC2
= V
CC3
= 12.5V
V
CC1
= 3~12.5V
Pi = 200mW
VSWR load 3: 1 all phase
All spurious output than
60dB below desired
signal
JEDEC --
EIAJ --
TOSHIBA 5-53Q
Weight: 35g
Unit in mm
TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general
can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the
buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and
to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or
damage to property.
In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the
most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the "Handling
Guide for Semiconductor Devices," or "TOSHIBA Semiconductor Reliability Handbook" etc..
000707EAA2
S-AU27AL,S-AU27AM,S-AU27AH
2001-02-02 2/3
CAUTION
This product has intersetting cap. Please pay attention for exceeding stress and foreign matter in your application.
And not to take away the cap.
Beryllia Ceramics is used in this product. The dust or vapor can be dangerous to humans. Do not break, cut, crush
or dissolve chemically. Dispose of this product properly according to law. Do not intermingle with normal industrial
or domestic waste.
SCHEMATIC
TEST FIXTURE
The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal
equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.). These TOSHIBA products are
neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or
failure of which may cause loss of human life or bodily injury ("Unintended Usage"). Unintended Usage include atomic energy
control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control
instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in this document
shall be made at the customer's own risk.
The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by
TOSHIBA CORPORATION for any infringements of intellectual property or other rights of the third parties which may result from its
use. No license is granted by implication or otherwise under any intellectual property or other rights of TOSHIBA CORPORATION or
others.
The information contained herein is subject to change without notice.
000707EAA2
PDF 
ZIP